Galvanized Steel Wire Rope Bending Direction Design Is Very Important

  Galvanized Steel Wire Rope bending direction design is very important

  In some mechanical equipment, Galvanized Steel Wire Rope need to play with the pulley or drum, in this friendship remind, equipment designers should pay attention to choose the correct Galvanized Steel Wire Rope bending direction, if the bending is wrong, will directly shorten the life of Galvanized Steel Wire Rope The

  Remind you that the designer in the design of mechanical equipment, should try to Galvanized Steel Wire Rope bending direction and roller or pulley position consistent, so that the formation of Galvanized Steel Wire Rope bending, also known as L bending. If the Galvanized Steel Wire Rope is designed for reverse bending (S-bend), the service life of the Galvanized Steel Wire Rope will be reduced by 50% to 70% compared with the same direction. This is because the Galvanized Steel Wire Rope is bent at the same time by bending pressure and Lateral pressure.

  Therefore, it is recommended that the design of such equipment, the designer should try to avoid the Galvanized Steel Wire Rope designed for reverse bending. If the join must be designed to reverse the direction of the bend, it should be when the distance between the pulley or the roller is designed to be larger.

  It is worth mentioning that, because the Galvanized Steel Wire Rope in the equipment is in direct contact with the pulley or drum used, so the performance of pulleys, drums will be the use of Galvanized Steel Wire Rope and work life have a great impact. In order to avoid premature scrap of Galvanized Steel Wire Rope, the designer should fully consider the pulley, roller material, diameter, etc., to rational design.