Galvanized Steel Wire Rope Is One Of The Indispensable Parts Of Rotary Drilling Rig Construction

Galvanized Steel Wire Rope is one of the indispensable parts of rotary drilling rig construction. The use of Galvanized Steel Wire Rope in the complex situation, in many cases, the Galvanized Steel Wire Rope will appear early scrapped. The following is on the use of Galvanized Steel Wire Rope ideas, I hope you do good use, get the maximum benefit.

1, Galvanized Steel Wire Rope unwinding and installation, should be used in the right way to prevent the Galvanized Steel Wire Rope kink. Also be careful not to make the surface of the rope covered with sand, so as not to exacerbate wear and tear, affecting the life of the rope.

2, the entire volume of steel Galvanized Steel Wire Rope when used, such as the need to cut off, the end should be tied or fused.

3, must be installed rope card should be fixed. Rope spacing of 5-6 times the Galvanized Steel Wire Rope diameter.

4, Galvanized Steel Wire Rope twist selection should be made in the bottom of the reel Galvanized Steel Wire Rope winding way.

5, Galvanized Steel Wire Rope wrapped in the reel should be arranged neatly, not around, otherwise it will cause serious work in the Galvanized Steel Wire Rope squeeze and crush, affecting the rope life.

6, the use of the new rope must be in the light load under the "running". This improves the service life of the Galvanized Steel Wire Rope. In use should also avoid excessive impact load on the Galvanized Steel Wire Rope damage.

7, the use of special attention should be paid in the process of drilling accurately calculate the distance, not excessive rope, to prevent the rope in the relaxed state of the intersection caused by structural damage to the entire Galvanized Steel Wire Rope scrapped.

8, for multi-layer winding equipment, Galvanized Steel Wire Rope in the use of "bite rope" is inevitable. Suggested in the use of "bite rope" parts often check and strengthen the lubrication, or regular "channeling rope" cut off, staggered "bite rope" parts.

9, Galvanized Steel Wire Rope put into use, the performance will be gradually reduced. Therefore, the new rope in the use of a period of time should always check the Galvanized Steel Wire Rope prone to damage to the site, such as Galvanized Steel Wire Rope "bite rope" parts, reel under the Galvanized Steel Wire Rope, a sharp impact through the pulley at the rope and out of the reel Galvanized Steel Wire Rope parts, Through regular inspection for the rational and safe use of Galvanized Steel Wire Rope to provide the basis.

10, broken wire processing

When the Galvanized Steel Wire Rope appears still need to be used when the wire should be broken wire in a timely manner. You can use wire clamp clamp broken wire head, before and after repeated bending to the wire cut off. After this treatment, wire breakage will be clamped between the rope, will not cause damage to the use of Galvanized Steel Wire Rope. The Galvanized Steel Wire Rope must be replaced when the number of wires in a twist pitch reaches 10% of the total number of outer wires.

11, recommended

As the rotary drilling rig Galvanized Steel Wire Rope work is a single rope lifting, that is, Galvanized Steel Wire Rope in the work of free rotation, based on safety and ease of operation considerations, in the purchase of Galvanized Steel Wire Rope should be preferred to use anti-rotating Galvanized Steel Wire Rope.